(Orginal: Fehler im NC-Programm: falsche Koordinaten des Kreismittelpunkts oder Zielpunkts (Radiusabweichung zwischen Start und Zielpunkt grösser 60um) oder Kreisradius grösser als 16m bei G9/G55/G56. Following code will bring an error at line N19Ĭontrol gives an error 95 which means "Error in the NC program: wrong coordinates of the circle center or destination point (radius difference between the start and finish point greater 60um) or radius greater than 16m at G9/G55/G56." ![]() It's not possible to edit a line with two G-codes on a same line in the controlģ. It does not accept P in the front of program nameĢ. ![]() ![]() Thanks for the quick reply, but sorry to tell that it still does not work.ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |